Official Bank 0/70

Fortinet NSE 7 – SD-WAN 7.0 (NSE7_SDW-7.0) - Fortinet Exam Questions

Last updated on June 20, 2026

97% Exam Compliance
70 Total Questions
1
Question
Refer to the exhibits. Exhibit A -

Exhibit

Edit Performance SLA Name Level3_DNS IP Version IPv4 IPv6 Probe Mode Active Passive Prefer Passive Protocol Ping TCP ECHO UDP ECHO HTTP TWI Server 4.22.1 4.222 Participants AlI SD-WAN Members Specify port1 # port2 2 Entries Enable Probe Packets SLA Targets O + Add Target Link Status Interval 500 Milliseconds Failure Before Inactive 3 (max 3600) (max 3600) Restore Link After 2 Action When inactive
Update Static Route
Cascade Interfaces Exhibit B-

Exhibit

Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SD-WAN member status, the routing table, and the performance SLA status.
If port2 is detected dead by FortiGate, what is the expected behavior?
Options
A Port2 becomes alive after three successful probes are detected.
B The administrator manually restores the static routes for port2, if port2 becomes alive.
C FortiGate removes all static routes for port2.
D Host 8.8.8.8 is reachable through port1 and port2.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

2
Question
Refer to the exhibit.

Exhibit

The device exchanges routes using IBGP. Which two statements are correct about the IBGP configuration and routing information on the device? (Choose two.)
Select 2
Options
A You can run the get router info routing-table database command to display the additional paths.
B ibgp-multipath is disabled.
C Each BGP route is three hops away from the destination.
D additional-path is enabled.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

3
Question
Which are two benefits of using CLI templates in FortiManager? (Choose two.)
Select 2
Options
A You can reference meta fields.
B You can configure FortiManager to sync local configuration changes made on the managed device,
to the CLI template.
C You can configure interfaces as SD-WAN members without having to remove references first.
D You can configure advanced CLI settings.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

4
Question
Refer to the exhibits.

Exhibit

Exhibit A Exhibit B -

Exhibit

Exhibit A shows the configuration for an SD-WAN rule and exhibit B shows the respective rule status, the routing table, and the member status. The administrator wants to understand the expected behavior for traffic matching the SD-WAN rule. Based on the exhibits, what can the administrator expect for traffic matching the SD-WAN rule?
Options
A The traffic will be load balanced across all three overlays.
B The traffic will be routed over T_MPLS_0.
C The traffic will be routed over T_INET_0_0.
D The traffic will be routed over T_INET_1_0.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

5
Question
Refer to the exhibits. Exhibit A

Exhibit

Exhibit B

Exhibit

Exhibit A shows the SD-WAN performance SLA configuration, the SD-WAN rule configuration, and the application IDs of Facebook and YouTube. Exhibit B shows the firewall policy configuration and the underlay zone status. Based on the exhibits, which two statements are correct about the health and performance of port1 and port2? (Choose two.)
Select 2
Options
A The performance is an average of the metrics measured for Facebook and YouTube traffic passing through the member.
B FortiGate identifies the member as dead when there is no Facebook and YouTube traffic passing through the member.
C FortiGate is unable to measure jitter and packet loss on Facebook and YouTube traffic.
D Non-TCP Facebook and YouTube traffic are not used for performance measurement.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

Finish Practice?

Are you sure you want to finish? This will end your practice session.