Logo ExamsQA
Exit
Official Bank 0/80

Fortinet NSE 7—Enterprise Firewall 7.2 (NSE7_EFW-7.2) - Fortinet Exam Questions

Last updated on June 20, 2026

97% Exam Compliance
80 Total Questions
1
Question
Exhibit.

Exhibit

Refer to the exhibit, which shows the output from the webfilter fortiguard cache dump and webfilter categories commands. Using the output, how can an administrator determine the category of the training.fortinet.com am website?
Options
A The administrator must add both the Pima in and Iphex values of 34 to get the category number
B The administrator must convert the first two digits of the Domain hex value to a decimal value
C The administrator must convert the first three digits of the IP hex value to binary
D The administrator can look up the hex value of 34 in the second command output.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

2
Question
Refer to the exhibit, which shows a routing table.

Exhibit

What two options can you configure in OSPF to block the advertisement of the 10.1.10.0 prefix? (Choose two.)
Select 2
Options
A Configure a distribute-list-out
B Disable Redistribute Connected
C Configure a route-map out
D Remove the 16.1.10.C prefix from the OSPF network
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

3
Question
Refer to the exhibit, which contains a partial OSPF configuration.

Exhibit

What can you conclude from this output?
Options
A FortiGate restarts if the topology changes.
B The restarting router sends gratuitous ARP for 30 seconds.
C Neighbors maintain communication with the restarting router.
D The router sends grace LSAs before it restarts.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

4
Question
Which two statements about the BFD parameter in BGP are true? (Choose two.)
Select 2
Options
A The two routers must be connected to the same subnet.
B It allows failure detection in less than one second.
C It detects only two-way failures.
D It is supported for neighbors over multiple hops.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

5
Question
Exhibit.

Exhibit

Refer to the exhibit, which contains a partial policy configuration. Which setting must you configure to allow SSH?
Options
A Include SSH in the Application field
B Select an application control profile corresponding to SSH in the Security Profiles section
C Specify SSH in the Service field
D Configure pot 22 in the Protocol Options field.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

Finish Practice?

Are you sure you want to finish? This will end your practice session.