Logo ExamsQA
Exit
Official Bank 0/214

Nokia Virtual Private Routed Networks Exam (4A0-106) - Nk Exam Questions

Last updated on June 20, 2026

97% Exam Compliance
214 Total Questions
1
Question
Which of the following VPRN topologies must a customer implement to allow a given VRF to include routes from different VPRNs?
Options
A An extranet VPRN
B A hub and spoke VPRN
C Either a hub and spoke or an extranet VPRN
D Either a full mesh or a hub and spoke VPRN
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

2
Question
Which of the following about eiBGP Load Balancing is FALSE?
Options
A The RD of the VPRN on the local PE must be different from the RD of the remote PEs.
B Is enabled in the config>router>bgp context
C ecmp and multipath must be configured within the VPRN instance.
D Allows a PE router to load share traffic across routes learned from both direct CE-PE peerings and MP-BGP peerings.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

3
Question
Which command is used to generate the output from an Nokia 7750 SR shown below?

Exhibit
Options
A Show service id 3 base
B Show service 3 base
C Show service id 3
D Show service 3
E Show service 3 detail
F Show service id 3 detail
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

4
Question
Click the exhibit.

Exhibit

The headquarter sites of VPRN 10 and VPRN 20 are part of an extranet VPRN. Which route targets should be exported under the VPRN 20 service on router R1?
Options
A target:65100:1 and target:65100:2
B target:65100:1 and target:65100:3
C target:65100:2 and target:65100:3
D target:65100:1, target:65100:2 and target:65100:3
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

5
Question
Click the exhibit. A Carrier Supporting Carrier (CSC) VPRN is configured on an Nokia 7750 SR for a customer carrier

who is an Internet Service Provider (ISP). Which of the following configuration steps is NOT required?
Options
A Configuring a policy on each CSC-CE to advertise local PE addresses to the network provider.
B Configuring labeled iBGP sessions between PEs residing in different customer carrier sites.
C Configuring labeled eBGP sessions between CSC-CE and CSC-PE routers.
D Advertising the received system addresses of remote PEs using either iBGP or IGP/LDP within each customer carrier site.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

Finish Practice?

Are you sure you want to finish? This will end your practice session.