Logo ExamsQA
Exit
Official Bank 0/65

Service Provider Routing and Switching – Specialist (JNCIS-SP) Exam (JN0-362) - Juniper Exam Questions

Last updated on June 20, 2026

97% Exam Compliance
65 Total Questions
1
Question
Which two functions are performed by the OSPF designated router? (Choose two.)
Select 2
Options
A It advertises link-state information to the AS
B It designates some routers as inactive when not needed
C It chooses the backup designated router
D It forms adjacencies with all the other OSPF routers on the link
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

2
Question
Exhibit

Click the Exhibit button. Your co-worker configures the ge-0/0/0 interface with an IPv6 address of 2001:db8:0:9::/64. After committing the configuration, your co-worker executes the command shown in the exhibit. What is the fe80::206:aff:fe0e:e01/64 address in this scenario?
Options
A the multicast address
B the loopback address
C the link-local address
D the statically assigned address
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

3
Question
Click the Exhibit button.

Exhibit

Both configuration hierarchies shown in the exhibit have been committed to your MX Series device. Which two statements are true in this scenario? (Choose two.)
Select 2
Options
A Traffic destined to 10.3.0.1 will not use the R1-to-R6 LSP as a next hop
B Traffic destined to 10.3.0.1 will use the R1-to-R6 LSP as a next hop
C The active 10.3.0.0/24 prefix installed in the route table will have a route preference of 7
D The active 10.3.0.0/24 prefix installed in the route table will have a route preference of 5
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

4
Question
Which statement about a virtual-router type of routing instance is correct?
Options
A It is the only routing instance type supported on Junos devices
B It is used to separate large networks into smaller administrative entities
C It is used to create and maintain separate routing and forwarding tables
D It is used in Layer 3 VPN implementations
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

5
Question
Click the Exhibit button.

Exhibit

(edit interfaces] unit 0 l user@router# show ge-0/0/0 f
address 10.1.1.5/31;
}
}
unit 0 l ge-0/0/1 l family inet | family inet |
address 10.1.1.21/31;
family mpis;
family mpis;
}
}
family inet f 100 ( unit 0 |
address 192.168.0.2/32;
}
[edit protocols bgp group BGP] user@router* show multihop:
local-address 192.168.0.2;
hold-time 30;
family inet ( family inet-vpn | family inet6 ( family ineto-vpn (
unicast;
unicast;
unicast;
unicast;
family 12vpn 1
signaling;
family route-target;
peer-as 65514;
local-as 65514;
Referring to the exhibit, which two statements are true? (Choose two.)
Select 2
Options
A The configuration is for an external BGP session
B The local-address statement is required for the BGP session to establish correctly
C The configuration is for an internal BGP session
D The multi-hop statement is required for the BGP session to establish correctly
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

Finish Practice?

Are you sure you want to finish? This will end your practice session.