Logo ExamsQA
Exit
Official Bank 0/327

Securitys: 392 (JN0-634) - Juniper Exam Questions

Last updated on June 20, 2026

97% Exam Compliance
327 Total Questions
1
Question
Click the Exhibit button.

-- Exhibit –

Exhibit

-- Exhibit --
In the network shown in the exhibit, you want to forward traffic from the employees to ISP1 and ISP2. You want to forward all Web traffic to ISP1 and all other traffic to ISP2. However, your configuration is not producing the expected results. Part of the configuration is shown in the exhibit. When you run the show route table isp1 command, you do not see the default route listed. What is causing this behavior?
Options
A The show route table isp1 command does not display the default route unless you add the exact 0.0.0.0/0 option.
B The isp1 routing instance is configured with an incorrect instance-type.
C The device is not able to resolve the next-hop.
D The autonomous system number is incorrect, which is preventing the device from receiving a default route from ISP1.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

2
Question
You have configured persistent NAT in your NAT rule base. You create a security policy in the direction of external to internal.

Which persistent NAT parameter should you configure?
Select 2
Options
A any-remote-host
B target-host-port
C target-host
D all-remote-host
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

3
Question
You have been asked to configure traffic to flow between two virtual routers (VRs) residing on two unique logical systems (LSYSs) on the same SRX5800.

How would you accomplish this task?
Options
A Configure logical tunnel interfaces between VR1 and VR2 and security policies that allow relevant traffic between VR1 and VR2 over that link.
B Configure an interconnect LSYS to facilitate a connection between LSYS1 and LSYS2 and relevant policies to allow the traffic.
C Configure a security policy that contains the context from LSYS1 to LSYS2 and relevant match conditions in the rule set to allow traffic between the IP networks in VR1 and VR2.
D Configure a security policy that contains the context from VR1 to VR2 to permit the relevant traffic.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

4
Question
You are asked to deploy a group VPN between various sites associated with your company. The gateway devices at the remote locations are SRX240 devices.

Which two statements about the new deployment are true? (Choose two.)
Select 2
Options
A The networks at the various sites cannot use NAT.
B The participating endpoints in the group VPN cannot be part of a chassis cluster.
C The participating endpoints in the group VPN can belong to a chassis cluster.
D The networks at the various sites must use NAT.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

5
Question
Your company is in the process of deploying a VPN network 10 connects its sites Traffic will predominantly access resources at the central site. However, on occasion, traffic must be transported
from one spoke site to another.

Which two methods will provide the desired connectivity? (Choose two.)
Select 2
Options
A a hub-and-spoke IPSec VPN using a separate multipoint secure tunnel on each spoke device
B a hub-and-spoke IPSec VPN using a separate secure tunnel unit for each spoke device
C a hub-and-spoke IPSec VPN using a multipoint secure tunnel interface on all devices
D a hub-and-spoke IPSec VPN using a multipoint secure tunnel interface on the hub device
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

Finish Practice?

Are you sure you want to finish? This will end your practice session.