Logo ExamsQA
Exit
Official Bank 0/54

Specialist – Implementation Engineers: 54 (DES-4421) - EMC Exam Questions

Last updated on June 20, 2026

97% Exam Compliance
54 Total Questions
1
Question
When performing “A1 the Box” management, what must be done to successfully connect to the Management Module?
Options
A Change the baud rate to 128000
B Connect cables to the KVM
C Attach standard A-to-A USB cable to a laptop
D Configure PuTTY for a serial connection
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

2
Question
While servicing an MX7000 chassis a system administrator logs into OME-M and receives a Chassis
Mismatch error.

What should be the next step taken by the administrator?
Options
A Reset Peer or the Local IOM
B Perform firmware update
C Clear the configuration
D Force Active/Clear configuration
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

3
Question
After installing a supported OS from a bootable ISO on an MX740c sled, an administrator discovers that not all the hardware is property detected by the OS. They plan to reinstall the OS.

What should the administrator do to resolve this issue through OS installation?
Options
A Modify the bootable ISO to remove faulty drivers and boot directly from the bootable ISO
B Modify the bootable ISO to remove faulty drivers and use the OS deployment feature
C Update the Dell OS Driver Pack and use the OS Deployment feature
D Update the Dell OS Driver Pack and boot directly from the bootable ISO
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

4
Question
What is a benefit of SmartFabric Services Mode?
Options
A Load balancing for management layers
B Load balancing for application layers
C Topology validation and self-healing
D Automatic detection of packet collisions
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

5
Question
Which command(s) is supported in the current PowerEdge MX Redfish implementation?
Options
A PUT only
B HEAD and PUT
C GET and DELETE
D PUT and DELETE
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

Finish Practice?

Are you sure you want to finish? This will end your practice session.