Logo ExamsQA
Exit
Official Bank 0/92

Dell PowerEdge Professional (DCPPE-200) - Dell Exam Questions

Last updated on June 20, 2026

97% Exam Compliance
92 Total Questions
1
Question
An engineer needs to configure network port partitions for four networks that will be used on the

- Partition 1 – Management network
server.

- Partition 2 – VM Live Migration network

- Partition 3 – Production VM network

- Partition 4 – Development VM network

The engineer needs to make sure the following conditions are met:

- Management and Live Migration networks do NOT exceed 1Gb

- Production VM network can use 10Gb but is guaranteed 5Gb during heavy use

- Development VM network has maximum bandwidth capability when NOT in use by the other
networks Which network port partition bandwidth settings should the engineer set?

Exhibit
Options
A Partition 1 Partition 2 Partition 3 Partition 4 Relative Bandwidth Weight 009040Maximum Bandwidth1010100100
B Partition 1 Partition 2 Partition 3 Partition 4 Relative Bandwidth Weight 1153Maximum Bandwidth111010
C Partition 1 Partition 2 Partition 3 Partition 4 Relative Bandwidth Weight 1010 50 30 Maximum Bandwidth 1010 100 100
D Partition 1 Partition 2 Partition 3 Partition 4 Relative Bandwidth Weight 0094Maximum Bandwidth1153
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

2
Question
An engineer is deploying a new server node into an existing chassis for a virtualization cluster. The existing cluster nodes have many modified BIOS settings to meet workload needs.

How should the engineer quickly deploy the new server node with matching BIOS settings?
Options
A Use the CMC Server Profiles to clone an existing server profile.
B Use the iDRAC GUI to replicate from an existing server profile.
C Use the Lifecycle Controller to mirror a cluster member profile.
D Use System Setup to configure dynamic profile settings based on workload.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

3
Question
Exhibit

An engineer is configuring VLT between two MXL switches. The engineer runs a show vlt brief command on one of the MXLs and receives the status shown in the exhibit. What should the engineer verify to fix the issue?
Options
A Both MXLs run the same firmware version
B VLT cables are plugged in and have a link light
C Both MXLs are powered on and fully booted into the OS
D MXLs can ping each other on their management IPs
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

4
Question
An engineer needs to assign two PCIe NICs and a GPU to a server node in a VRTX chassis.

Which two steps are required to complete this task?
Options
A Power off the node. Upgrade the CMC license.
B Enable PCIe Ride-through. Power off the node.
C Update all firmware. Upgrade the CMC license
D Enable PCIe Ride-through. Update all firmware.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

5
Question
An engineer installs a second Shared PERC Internal card into a VRTX and is performing post installation tasks. The Fault Tolerant Status is NOT Healthy/Normal as expected.

What is the cause?
Options
A The Shared PERC cards are NOT at the same firmware level.
B The physical disks were removed from the chassis before initialization finished.
C One or more nodes are still assigned virtual disks.
D The VRTX was NOT licensed for two Shared PERC Internal cards.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

Finish Practice?

Are you sure you want to finish? This will end your practice session.