Logo ExamsQA
Exit
Official Bank 0/60

Real 300-535 (300-535) - Cisco Exam Questions

Last updated on June 20, 2026

97% Exam Compliance
60 Total Questions
1
Question
A Cisco NSO service has just been deployed. Which Cisco NSO CLI command is used to inspect the resulting device configuration changes before the changes are pushed to the network?
Options
A show dry-run output
B commit dry-run outformat native
C pseudo-commit
D show service impact
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

2
Question
Which schema allows device configuration elements to be enclosed within a remote procedure call message when NETCONF is implemented?
Options
A YAML
B XML
C JSON
D JSON-RPC
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

3
Question
Which command configures the remote peer when the Cisco IOS XR Traffic Controller is used?
Options
A peer ipv4 192.168.0.3
B state ipv4 192.168.0.3
C state-sync ipv4 192.168.0.3
D peer-sync ipv4 192.168.0.3
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

4
Question
Refer to the exhibit.

Exhibit

XTC has been configured by an engineer. What does the IPv4 address represent on the snippet?
Options
A destination address of the router on which it listens for PCEP
B configured for the local peer for state synchronization
C configured for the remote peer for state synchronization
D local address of the router on which it listens for PCEP
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

5
Question
Refer to the exhibit.

Exhibit

What is the effect of the script on the device?
Options
A It compares the configuration to the device. If it matches, the device sends back an HTTP 204 status code.
B It replaces the entire configuration for GigabitEthernet2 on the device using RESTCONF.
C It merges the new configuration with the existing configuration on the device using RESTCONF.
D All interfaces except GigabitEthernet2 are reset to their default configurations.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

Finish Practice?

Are you sure you want to finish? This will end your practice session.