Logo ExamsQA
Exit
Official Bank 0/167

Troubleshooting Cisco Data Center Infrastructure (300-615 DCIT) Exam (300-615) - Cisco Exam Questions

Last updated on June 20, 2026

97% Exam Compliance
167 Total Questions
1
Question
Refer to the exhibit. 151/161

Exhibit

Storage Array ! fc1/46 fc1/ fc1/47-48 ! fc1/31-32 VSAN 100 Fabric Interconnects in End Host mode @ FI-A

*E *

*
! #= UCS-1 N9K-1 N9K-1# no shutdown ! feature fcoe slot 1 port 44-48 type fc vsan database vsan 100 vsan 100 interface fc1/46-48 interface fc1/46-48

Exhibit

Refer to the exhibit. UCS- 1 fails to connect to the storage array. Which action resolves the issue?
Options
A Configure N-Port ID Virtualization on FI-A.
B Enable N9K-1 mode to N-Port ID Virtualization.
C Implement N-Port Mirtualization on N9K-1.
D Set the FI-A mode to FC End Host mode.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

2
Question
Refer to the exhibit.

Exhibit

An engineer discovers that if the vPC peer link goes down, half of the devices in VLAN 20 experience connectivity issues with the external networks Which action resolves the issue?
Options
A Allow non-vPC VLANs on a second trunk between the two vPC peers
B Add the non-vPC SVIs in the dual-active exclude VLAN list
C Exclude the non-vPC VLANs from vPC peer link
D Configure a dedicated Layer 3 link between vPC peers
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

3
Question
Refer to the exhibit.

Exhibit

The connection between a Cisco Nexus 5548UP switch and a Cisco MDS switch fails to initialize. What is the cause of the issue?
Options
A The SFP is unsupported.
B Trunk mode must be activated.
C The interface is in an incorrect mode.
D VSAN 1 is suspended.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

4
Question
Refer to the exhibit.

Exhibit

Interface fc1/5 is offline. Which action should be taken to troubleshoot the issue?
Options
A Update the FLOGI database to contain the FLOGI entries for interface fc1/5 in VSAN 100.
B Update the FCNs database to contain names for VSAN 100.
C Configure the upstream ports and the server ports to be in VSAN 100.
D Activate the correct zoneset for VSAN 100.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

5
Question
Refer to the exhibit.

Exhibit

The vPC between switch1 and switch2 does not work. Which two actions resolve the problem? (Choose two.)
Select 2
Options
A Configure one of the switches as primary for the vPC.
B Activate VLANs on the vPC.
C Correct the configuration of the vPC peer link and the vPC peer keepalive.
D Match the vPC domain ID between the two devices.
E Configure the IP address on the interface.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

Finish Practice?

Are you sure you want to finish? This will end your practice session.