Logo ExamsQA
Exit
Official Bank 0/71

Implementing Cisco Service Provider VPN Services (300-515 SPVI) Exam (300-515) - Cisco Exam Questions

Last updated on June 20, 2026

97% Exam Compliance
71 Total Questions
1
Question
In a typical service provider environment, which two tools are used to help scale PE router connectivity requirements? (Choose two.)
Select 2
Options
A originator ID
B confederations
C cluster ID
D VPNv4 address family
E route reflectors
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

2
Question
An engineer is troubleshooting AToM on an IOS XE router and receives an error when creating the xconnect. Which command does he need to complete to create the xconnect in AToM?
Options
A protocol 12tpv3
B protocol none
C encapsulation 12tpv3
D encapsulation mpls
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

3
Question
Refer to the exhibit. Router 1 is a route reflector client within a service provider core PE1 cannot see VPNv4 routes received from the ASBR PE1 only has an iBGP relationship with Router 1. Which action resolves this issue?
Options
A Configure Router 1 as a route reflector for PE1 under the VPNv4 address family.
B Enable BGP default ipv4-unicast
C Configure PE1 to have an eBGP relationship with Router 1.
D Activate PE1 as a neighbor under the IPv4 address family.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

4
Question
Which statement describes the no bgp default route-target filter command?
Options
A Prefixes that are received with route targets that are not imported at the PE are not accepted.
B Prefixes that are received with route targets that are not imported at the PE are accepted.
C Prefixes that are received with route targets and distinguisher are not accepted.
D Prefixes that are received with route targets and distinguisher are accepted.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

5
Question
You are troubleshooting ARP connectivity issues for an Ethernet interface on an IOS XR network that runs IS- IS. You verify that the IGP protocol is running, but an ARP entry has not yet been created.

Which action should you take?
Options
A debug ping packets
B verify the RIB table routes
C debug ARP
D ping the connected neighbor
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

Finish Practice?

Are you sure you want to finish? This will end your practice session.