Logo ExamsQA
Exit
Official Bank 0/70

Integrating Protected HPE Storage Solutions Exam (HPE0-J50) - HP Exam Questions

Last updated on June 20, 2026

97% Exam Compliance
70 Total Questions
1
Question
A storage integrator is handing over an installed HPE StoreOnce solution to the customer and demonstrates the default usernames and passwords for the StoreOnce GUI. The storage administrator is interested in creating another local administrator account.

How can the storage administrator create an administrator account?
Options
A Use the LDAP Integration screen in the StoreOnce GUI.
B Use the native user management feature in the operating system.
C Create the new account in Integrated Lights-Out (iLO) and synchronize the account to StoreOnce.
D Use the Add User link in the User Management screen in the StoreOnce GUI.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

2
Question
Refer to the exhibit.

Exhibit

The administrator has presented an HPE 3PAR StoreServer virtual volume to a server. A single virtual volume is seen as two different offline disks on a Windows 2012 R2 server. What must be done to correct the issue?
Options
A Install HPE 3PAR DSM MPIO and reboot the server.
B Install the latest HBA driver and reboot the server.
C Install 3PAR host explorer and start service.
D Install the MPIO feature and reboot the server.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

3
Question
A storage integrator is planning an HPE MSA Storage installation.

What needs to be taken into consideration when implementing a SAS connected model?
Options
A SAS expander or a SAS switch is supported only with non-redundant paths.
B Up to four servers with non-redundant paths can be connected.
C Up to four servers with redundant paths can be connected.
D SAS expander or a SAS switch is required if eight or more servers are connected.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

4
Question
Exhibit

Refer to the exhibit. Which command can be used in the CLI console to set the static IP address and DNS server for an HPE StoreOnce device?
Options
A run setup
B net set wizard
C setup network
D create network
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

5
Question
HOTSPOT When using the CLI for performance monitoring on an HPE 3PAR array, for which component in the datapath would the “stavlun” command give an output? (Click on the correct option.)

Exhibit
HOTSPOT
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

Finish Practice?

Are you sure you want to finish? This will end your practice session.