Implementing Cisco Enterprise Wireless Networks (300-430 ENWLSI) Exam (300-430) - Cisco Actual Exam Questions
Last updated on April 14, 2026
Where is a Cisco OEAP enabled on a Cisco Catalyst 9800 Series Wireless Controller?
RF Profile
Flex Profile
Policy Profile
AP Join Profile
to join the discussion
No discussions yet. Be the first to ask!
Delete Comment
Are you sure? This action cannot be undone.
During the EAP process and specifically related to the client authentication session, which encrypted
to join the discussion
No discussions yet. Be the first to ask!
Delete Comment
Are you sure? This action cannot be undone.
Refer to the exhibit. An ACL is configured to restrict access for BYOD clients. The ACL must redirect devices to the guest portal. To which two devices on the local network must the ACL allow access other than the DHCP server? (Choose two.)
RADIUS server
DNS server
Cisco ISE
SNMP server
WLC
to join the discussion
No discussions yet. Be the first to ask!
Delete Comment
Are you sure? This action cannot be undone.
A customer has 10 Cisco 3700 Series APs in autonomous mode installed at a warehouse facility. A new VoWLAN service is being deployed to support Cisco WLAN phones. All wired QoS is configured. The customer requires that all VoWLAN signaling and RTP traffic be prioritized between the wired and wireless networks. Which configuration is required?
Apply a Cisco AVC profile for RTP and signaling on all the APs.
Switch on Fastlane on all the APs.
Set EDCA on all the APs to optimize voice and video.
Enable AWID priority mapping on all the APs
to join the discussion
No discussions yet. Be the first to ask!
Delete Comment
Are you sure? This action cannot be undone.
A wireless controller has a RADIUS server configured globally. Another RADIUS server is mapped for WLAN A in this controller. Which RADIUS server does the controller use for authenticating clients from WLAN A?
RADIUS server that is globally configured
first the RADIUS server that is mapped for WLAN A, and if authentication fails, it reverts to the RADIUS server that is globally configured
RADIUS server that is mapped for WLAN A
first the RADIUS server that is globally configured, and if authentication fails, it reverts to the RADIUS server that is mapped for WLAN A
to join the discussion
No discussions yet. Be the first to ask!
Delete Comment
Are you sure? This action cannot be undone.
Finish Practice?
Are you sure you want to finish? This will end your practice session.