Official Bank 0/159

Check Point Certified Security Master - R80 Exam (156-115) - Checkpoint Actual Exam Questions

Last updated on April 13, 2026

97% Exam Compliance
159 Total Questions
1
Question

What occurs when Bypass Under Load activated?

Options
A

Packets are forwarded to the destination without checking the packets against the firewall rule base

B

Packets are forwarded to the destination without performing IPS analysis

C

To still ensure a minimum level of data integrity, the system revert to the use of MD5 instead of SHA-1, since former produces an output smaller than the latter

D

The amount of the state table entries is decreased according to the LRU (least recently used) algorithm

Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

2
Question

Which command should be used to insert fw monitor before secxl_sync module?

Options
A

fw monitor –pi –secxl_sync –o capture.cap

B

fw monitor –pl –secxl_sync –o capture.cap

C

fw monitor –pO –secxl_sync –o capture.cap

D

fw monitor –e “accept –pi –secxl_sync;” –o capture.cap

Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

3
Question

Consider the IPv6 address: 2101:0DA0:080B:4114:0000:0000:0000:0001. According to IPv6 IP shortening rules, what address can this be shortened to?

Options
A

2101:0DA0:080B:4114::8:0

B

2101:0DA0:80B:4114::0

C

2101:0DA0:080B:4114::8:1

D

2101:0DA0:80B:4114::1

Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

4
Question

If cluster members are geographically separated and the time to detect a failover needs to be longer, what timer needs to be adjusted?

Options
A

fwha_timer_cpha_res

B

fwha_timer_dist_res

C

fwha_geosync_timer

D

fwha_timer_sync_res

Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

5
Question

When troubleshooting static NAT, you would follow all the steps below, EXCEPT:

Options
A

Verify NAT configuration

B

Debug NAT

C

Run “fw tab -t fwx_alloc”

D

Run “fw ctl arp” command

Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

Finish Practice?

Are you sure you want to finish? This will end your practice session.