Logo ExamsQA
Exit
Official Bank 0/86

Juniper Service Provider Routing and Switching, Specialist (JN0-363) - Juniper Exam Questions

Last updated on June 20, 2026

97% Exam Compliance
86 Total Questions
1
Question
You are implementing traffic engineering in your MPLS network. You must ensure that the MPLS routes are used to traverse your network. Your solution should not affect IGP routes in your route tables. In this scenario, which traffic engineering setting will accomplish this behavior?
Options
A bgp-igp
B bgp-igp-both-ribs
C mpls-forwarding
D bgp
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

2
Question
Which statement is correct about the FE80;:/10 prefix?
Options
A This prefix range is reserved for multicast applications
B This prefix range is used on the loopback interface.
C This prefix range is used for the link local address.
D This prefix range is not reserved.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

3
Question
What are two bridging concepts that are used to maintain an Ethernet switching table? (Choose two.)
Select 2
Options
A aging
B exporting
C learning
D timing
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

4
Question
Exhibit.

Exhibit

Referring to the exhibit, you have configured an aggregate route that represents the 172.21.0.0/24, 172.21.1.0/24, and 172.21.2.0/24 networks. However, when you view the routing table, your new
route hidden. Which action would you perform to determine the problem?
Options
A Verify that you have defined a metric value for the aggregate route.
B Verify that you have active contributing routes on the device.
C Verify that you have configured a policy on the device to accept aggregate routes.
D Verify that you have set the preference to a lower default value.
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

5
Question
Exhibit You are asked to configure the OSPF environment to prevent the DRother routers from participating in DR/BDR election. Referring to the exhibit, which command will accomplish this task?
Options
A set protocols ospf area 0.0.0.0 interface ge-0/0/1 interface-type nbma
B set protocols ospf area 0.0.0.0 interface ge-0/0/1 priority
C set protocols ospf area 0.0.0.0 interface ge-0/0/l priority 255
D set protocols ospf area 0.0.0.0 interface ge—0/0/1 interface-type p2p
Discussion (0 comments)

to join the discussion

Community Discussion

No discussions yet. Be the first to ask!

Finish Practice?

Are you sure you want to finish? This will end your practice session.