Alcatel-Lucent Advanced Troubleshooting (4A0-110) - Alcatel-Lucent Actual Exam Questions
Last updated on April 11, 2026
An operator has entered the following CLI commands to configured redistribution of OSPF routes into ISIS. None of the active OSPF routes are redistributed into ISIS, what is the problem in the CLI commands?
OSPF area has to be configured as NSSA
Default-action has to be configured as accept
Import policy has to be configured under OSPF
The policy is still in edit mode, therefore it will not take any effect
to protocol isis has to be added under entry 10
to join the discussion
No discussions yet. Be the first to ask!
Delete Comment
Are you sure? This action cannot be undone.
Based on the following CLI Output, why is the path toPod3-loose down?
Path toPod3-loose is down because it is secondary path with no standby configured
Path toPod3-loose is down because there is no explicit hop specified
Path toPod3-loose is down because CSPF is not enabled
Path toPod3-loose is down because the destination address 0.10.1.3 is not reachable
Path toPod3-loose is not down because the failure code is oError
to join the discussion
No discussions yet. Be the first to ask!
Delete Comment
Are you sure? This action cannot be undone.
Which command should be used to enable automatic synchronization for all software images and configuration on the Alcatel 7x50?
Admin redundancy synchronization boot-env
Admin redundancy synchronization config
Configure redundancy synchronize boot-env
Configure redundancy synchronize config
It is enabled by default
to join the discussion
No discussions yet. Be the first to ask!
Delete Comment
Are you sure? This action cannot be undone.
Two direct connected routers are running RIPv2, neighbors are up but there is no route in the RIP database. Review the configuration information below. What is the potential problem?
System interface is not added to the RIP protocol
No import policy is configured
No export policy is configured
Split-horizon has to be disabled in RIP
Message-size has to be configured with a non-zero value
to join the discussion
No discussions yet. Be the first to ask!
Delete Comment
Are you sure? This action cannot be undone.
VPRN 300 is configured on Node 4. BGP is being used as the PE-CE routing protocol. Node 2 is the CE router. The BGP session is not established between Node 4 and Node 2. What is missing in the configuration?
Type external has to be configured on Node 2 under group vrf
Autonomous-system has to be configured on Node 4 under vprn 300
Router-id has to be configured on Node 4 under vprn 300
Router-id has to be added under BGP on Node 2 E. EBGP will not work under VPRN
to join the discussion
No discussions yet. Be the first to ask!
Delete Comment
Are you sure? This action cannot be undone.
Finish Practice?
Are you sure you want to finish? This will end your practice session.